|
|
| |
| DEWATERING PUMPS |
| |
|
Construction : MBH Dewatering pumps are portable pumping units which have pump below and motor above construction. These are powered by squirrel cage induction motors suitable to 400/440 volts, 3 phase, 50 Hz AC supply, totally enclosed. The motor windings are water and oil resistant and ingress of water or moisture inside the motor due to seal failure or other reason will not render the pump in operative. The pump motor unit is of close coupled construction and the double casing design provides on effective water cooling of the motor by water flowing around the motor casing the motor is sealed by special mechanical seal so that the pumping media like waste water, storm water muddy and sandy water does not enter the motor chamber and damage the motor. All parts are made from specially selected material and processed to ensure long life under arduous operation conditions.
MBH Dewatering pumpsets are available on both type i.e. water filled, cooled & lubricated as well as oil filled, cooled & lubricated designs.
|
|
|
| |
|
Advantages : MBH Dewatering pumps are of simple and robust design and can withstand rough handling at construction sites and any other heavy duty applications. After installation, the MBH pump helps itself. Under normal conditions, these pumps require much less attendance before service in other words cost of labour is reduced to a minimum. Pumps have high overall efficiency and that means low powercosts. MBH Dewatering pumps can be operated in series to achieve higher heads.
|
| |
|
APPLICATIONS:
- Dewatering trenches
- Building construction sites
- Dam sites
- Mines
- Pits
|
|
TECHNICAL SPECIFICATION:
- Head : up to 1000 mtrs.
- Capacity : up to 1200 cu.mt/hr
- Stage : Single/Two
- Lubrication : Oil / Water
- H. P. : 1.5 to 200 H.P.
- Solid Size : up to 50 mm
- R.P.M. : 2900/1450
- Bearing : Ball Bearing / Bush Bearing
|
|
|
|
| |
| |
| SELF PRIMING CENTERIFUGAL PUMP |
| |
|
Material of Construction :
- Graded cast iron construction
- Dynamically Balanced CI / SS impeller
- EN 8 Shaft
- SS410 Sleeve
Features
- Self priming & Centrifugal mechanism
- Quick priming of dirty water
- Can handle solids upto 40 mm depending on pump model / size
- Pump alone can be coupled to motor / engine.
- Sturdy design
- Back pull out design No need to open suction / discharge pipe for maintenance.
- Monoblock / Non monoblock option available.
Applications
- Polluted liquid, muddy water or Fresh Water
- Dewatering basements, Trenches, Swimming pools, Construction Sites
- Onboard shift as bildge for desk wash & engine cooling
- Tiles & Marble factories
- Any application where priming is to be avoided
|
|
- Head : Upto 35 Mtrs.
- Capacity : upto 73 LPS
- Solid Size : 40 mm
- Drive : Engine / Motor
- Monoblock version available
|
|
|
|
